Inwells Car Alarm Manual

If its newly installed the ignition interuption relay may not have been installed. Either that or it has been hooked up worng. Only other thing you can do is check the code. To check if you have the correct code for programming follow these instructions: • wait for the alarm to immobilise itself – IE the LED flashes slowly • Turn the ignition on the LED will be constantly on, • Turn the ignition off, the LED will now flash, count the flashes for the first number in the override code. For example if the first number is 3, count three flashes of the LED. When the LED has flashed the amount of times that corresponds to the first number of the code turn the ignition switch on.

• Turn off the ignition and count the flashes for the next number of the code and so on until all the numbers in the override code have been entered. • If the code has been recognised the LED will flash very quickly for a few seconds, you are now in programming mode and the alarm is also disarmed. • If the LED has not flashed quickly - start again from the beginning. If the number is ‘0’ count 10 flashes of the LED. Answered on Mar 06, 2019.

Inwells car alarm with keyless entry. It comes with a users manual with a wiring diagram for installation. Car Alarm/Horn Question. Expert: ALARMTEK - 5/16/2009. Question I am writing this email to you out of pure frustration due to the fact that I purchased an Inwells remote start car alarm and realized upon installation that there was no. Automotive Car Alarm Security System >> Four Channel Inwells 3703B Alarm System. - Car door alarm / parking alarm. You should keep a copy of your Haynes manual.